Industrial Wireless Radio Controls
Basic
System Package Kit:
One Base
Transmitter, One Base Receiver
Two 34" Omni Antennas with 10ft coaxial cable, NEMA 4 Enclosures &
Instructions |
915428 |
Basic System Start Stop 154 |
|
Performance
•
5 miles ( 8 km)
line-of-sight w Omni antenna
• Extended range up to 20 km • Operation: 120/240VAC
or 12VDC •
Transmitter input N/O Dry contact
•
Receiver with signal strength indicator
• Relay Output SPDT, 6A Class 2 pilot duty
•
Heavy Duty NEMA4, IP65 UL Fiber enclosure
• License free 154MHz Industrial
MURS band • Factory configured systems, Ready to operate
• No setup or programming required
Operation:
Example
■ If Low
Level SW Close: , Pump Start.
■
If
High Level SW Close: , Pump
Stop.
System
with High and Low Indicators
|
|
|
Remote
operation for:
Pumps, Lighting,
Process, Alarms,
Gates, Valves.
■
Applications:
Industrial Monitoring, Pump control, Monitor remote
sites, Tank Level,
Lighting control, Remote Mobile system, PLC remote, SCADA,
Gates.
Factory process control, Alarms, Generators,
Solar, Wire replacement.
|
Supply power |
120/240VAC or
12VDC / 7watt |
Inputs |
N/O Normally
Open, digital dry contact |
Transmitter power |
per
FCC Part 15.249,
50mV/m @ 3m |
Transmission |
Digital Encoded
Gaussian_frequency-shift_keying |
Channels |
16 addresses per system
GFSK |
Input Wiring |
Din Terminals,
Dry Contact |
Response |
Loop 500 msec
|
Weight |
6.8 lb (3.40kg)
each unit |
(*) Dimensions |
12"W x
10"H x
6"D (300 x 250 x 150 mm) |
Specifications Digital Receiver
|
Supply power |
120/240VAC or
12VDC / 5watt |
Output |
Relay 6Amp, Class 2 pilot duty |
Frequency |
154MHz •
License free MURS band |
Configuration |
DIP switch factory
preset |
Compliance |
FCC CFR part 15.247, 95 sub E |
Wiring |
Screw Terminals |
Antenna Z |
50 Ohm |
Ambient temp |
14° to 140° F (-10° to 60°
C) |
Enclosure |
NEMA4, IP65
|
(*) Final Component layout and Dimension may vary
■
|
Typical
wiring application example
DISCLAIMER:
Radio control equipment
in not to be used in life safety.
Radio Installations shall be
performed by a certified professional. |
|